flashrom v0.9.7-r1711 on Linux 3.14.35-std452-amd64 (x86_64)
flashrom is free software, get the source code at http://www.flashrom.org

Calibrating delay loop... OK.
Found chipset "Intel H61". Enabling flash write... Warning: Setting Bios Control at 0xdc from 0x0a to 0x0b on H61 failed.
New value is 0x0a.
Warning: SPI Configuration Lockdown activated.
FREG0: Warning: Flash Descriptor region (0x00000000-0x00000fff) is read-only.
FREG2: Warning: Management Engine region (0x00001000-0x001fffff) is locked.
Not all flash regions are freely accessible by flashrom. This is most likely
due to an active ME. Please see http://flashrom.org/ME for details.
Writes have been disabled for safety reasons. You can enforce write
support with the ich_spi_force programmer option, but you will most likely
harm your hardware! If you force flashrom you will get no support if
something breaks. On a few mainboards it is possible to enable write
access by setting a jumper (see its documentation or the board itself).
PROBLEMS, continuing anyway
Found Macronix flash chip "MX25L6406E/MX25L6436E" (8192 kB, SPI) at physical address 0xff800000.
Reading flash... Transaction error!
Read operation failed!
FAILED.