Riku Viitanen has uploaded this change for review.
serprog: clean up documentation
* serprog.h doesn't exist, at least not in this repo
* in the doc, no other command has S_CMD_ prefix either
Change-Id: Ic83e7fd80840f2db0b006935a964721da0388068
Signed-off-by: Riku Viitanen <riku.viitanen@protonmail.com>
Reviewed-on: https://review.sourcearcade.org/c/flashprog/+/52
Reviewed-by: Nico Huber <nico.h@gmx.de>
Tested-by: Nico Huber <nico.h@gmx.de>
---
M Documentation/serprog-protocol.txt
1 file changed, 1 insertion(+), 3 deletions(-)
git pull ssh://review.coreboot.org:29418/flashrom refs/changes/99/80499/1
diff --git a/Documentation/serprog-protocol.txt b/Documentation/serprog-protocol.txt
index d58b8e9..b3d4fd0 100644
--- a/Documentation/serprog-protocol.txt
+++ b/Documentation/serprog-protocol.txt
@@ -84,7 +84,7 @@
lower than the one requested. If there is no lower frequency
available the lowest possible should be used. The value
chosen is sent back in the reply with an ACK.
- 0x15 (S_CMD_S_PIN_STATE):
+ 0x15 (S_PIN_STATE):
Sets the state of the pin drivers connected to the flash chip. Disabling them allows other
devices (e.g. a mainboard's chipset) to access the chip. This way the serprog controller can
remain attached to the flash chip even when the board is running. The user is responsible to
@@ -102,5 +102,3 @@
S_CMD_O_DELAY, S_CMD_O_EXEC.
In addition, support for these commands is recommended:
S_CMD_Q_PGMNAME, S_CMD_Q_BUSTYPE, S_CMD_Q_CHIPSIZE (if parallel).
-
-See also serprog.h.
To view, visit change 80499. To unsubscribe, or for help writing mail filters, visit settings.