Attention is currently required from: Arthur Heymans, Nicholas Chin.

View Change

1 comment:

• Patchset:

  • Patch Set #5:

    flashrom on Linux 6.0.0-2-amd64 (x86_64)
    flashrom is free software, get the source code at https://flashrom.org

    Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns).
    flashrom was built with GCC 12.2.0, little endian
    Command line (6 args): /usr/local/sbin/flashrom --verbose --progress --programmer internal --write 08433F20.bin
    Initializing internal programmer
    /sys/class/mtd/mtd0 does not exist
    No coreboot table found.
    Using Internal DMI decoder.
    DMI string chassis-type: "Desktop"
    DMI string system-manufacturer: "HP"
    DMI string system-product-name: " "
    DMI string system-version: " "
    DMI string baseboard-manufacturer: "HP"
    DMI string baseboard-product-name: "8433"
    DMI string baseboard-version: "11"
    W836xx enter config mode worked or we were already in config mode. W836xx leave config mode had no effect.
    Active config mode, unknown reg 0x20 ID: 89.
    Found chipset "AMD FP4/FP5/AM4" with PCI ID 1022:790e.
    Enabling flash write... SPI base address is at 0xfec10000
    Ryzen detected.
    SpiRomEnable=1, RouteTpm2Sp=0, PrefetchEnSPIFromIMC=1, PrefetchEnSPIFromHost=1
    (0x6f0c2105) SpiArbEnable=1, IllegalAccess=0, SpiAccessMacRomEn=0, SpiHostAccessRomEn=0, ArbWaitCount=7, SpiBusy=0
    ERROR: State of SpiAccessMacRomEn or SpiHostAccessRomEn prohibits full access.
    ROM strap override is not active
    PROBLEMS, continuing anyway
    The following protocols are supported: LPC, FWH.
    Probing for AMIC A49LF040A, 512 kB: probe_jedec_common: id1 0xf8, id2 0x0a, id1 is normal flash content, id2 is normal flash content
    ...
    Probing for Winbond W49V002A, 256 kB: probe_jedec_common: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content
    Probing for Winbond W49V002FA, 256 kB: probe_jedec_common: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content
    No EEPROM/flash device found.
    Note: flashrom can never write if the flash chip isn't found automatically.

    
    -----

    Here is the log for latest BIOS on this HP when you run flashrom.

To view, visit change 72058. To unsubscribe, or for help writing mail filters, visit settings.