Anastasia Klimchuk submitted this change.
serprog: clean up documentation
* serprog.h doesn't exist, so refer to .c source instead
* in the doc, no other command has S_CMD_ prefix either
Change-Id: Ic83e7fd80840f2db0b006935a964721da0388068
Signed-off-by: Riku Viitanen <riku.viitanen@protonmail.com>
Reviewed-on: https://review.coreboot.org/c/flashrom/+/80499
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Anastasia Klimchuk <aklm@chromium.org>
---
M Documentation/serprog-protocol.txt
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/serprog-protocol.txt b/Documentation/serprog-protocol.txt
index d58b8e9..3d4aa1a 100644
--- a/Documentation/serprog-protocol.txt
+++ b/Documentation/serprog-protocol.txt
@@ -84,7 +84,7 @@
lower than the one requested. If there is no lower frequency
available the lowest possible should be used. The value
chosen is sent back in the reply with an ACK.
- 0x15 (S_CMD_S_PIN_STATE):
+ 0x15 (S_PIN_STATE):
Sets the state of the pin drivers connected to the flash chip. Disabling them allows other
devices (e.g. a mainboard's chipset) to access the chip. This way the serprog controller can
remain attached to the flash chip even when the board is running. The user is responsible to
@@ -103,4 +103,4 @@
In addition, support for these commands is recommended:
S_CMD_Q_PGMNAME, S_CMD_Q_BUSTYPE, S_CMD_Q_CHIPSIZE (if parallel).
-See also serprog.h.
+See also serprog.c
To view, visit change 80499. To unsubscribe, or for help writing mail filters, visit settings.