Thank you for your help.
I extract your file and got M0130679901.h as Microcode but my board does
not work it did not show anything.
I use E3825.
In previous notes, you told "My guess is that you don't have
(under "Chipset"), which is an option you have to set in addition to
the stuff under "Console."
but in your config, you had not enabled this option.
Could you help me with this and Did you use 6 pins that are separated
on board for console port?
I do not know what is my problem .it did not show anything log.
Thank you for your time.
On Wed, Aug 1, 2018 at 2:04 AM David Hendricks <david.hendricks(a)gmail.com>
That header may be out of date
I had to manually download the microcode file corresponding to my
processor SKU from Intel. Use the link I sent you earlier to download
Baytrail_FSP_Gold4.tgz and see if the microcode headers included in
that tarball match your processor. The Atom on my Minnowboard Turbot
has a CPUID of 30679, so I needed to use M0130679901.h.
(note that the Minnowboard Max uses an Atom E3825, while the Turbot
uses an E3826 dual-core SoC or E3845 quad-core SoC)
On Mon, Jul 30, 2018 at 2:36 AM, zahra rahimkhani
for Microcode file I just it from coreboot source from this path
Is that good ?
On Sun, Jul 29, 2018 at 1:18 PM zahra rahimkhani <
> Hi David,
> Thank you very much for your guide.
> I got this comments on my config and changes it based on your config.
> But I can not see any thing on output.
> Could you tell me which Uart pins do you use on Minnowboard max
> I used it 6 pin that are separately on board .
> I would be grateful if you guide me .
> I got my new config here .
> Also , Could you tell me what is this parameter
> On Fri, Jul 27, 2018 at 11:06 AM David Hendricks
> <david.hendricks(a)gmail.com> wrote:
>> Hi Zahra,
>>> I got my config file here
>> Thanks, that helps a lot!
>> The last config that I tested is
>> If you diff my config and yours, it seems you have several options
>> disabled which I think you should try enabling:
>> You can find these by using the search function in `make menuconfig`.
>> Press '/' and type a Kconfig option.
>>> I would be grateful if you check my config and tell me what is
>>> in Coreboot and how
>>> I use it.
>>> and How I find Intel ME file for my board and GBE for a network on
>> ifdtool is a tool for viewing and manipulating an Intel Flash
>> binary. The flash descriptor is a 4KB
data structure at the start of
>> ROM's address space (offset
>> To build it: `make -C util/ifdtool`
>> To run it: `util/ifdtool/ifdtool`
>> You'll probably want to use the '-x' option to extract the
>> modules from an existing Minnowboard Max firmware image (e.g. the
>> that comes with the board). That will
give you the ME and GBE files.