PCI bus error on VT6102 ethernet

Hi,

When I tried to enable vt6102 ethernet, i got following error. 
After tracking down the code, I found that it happen because ISR0 (0xc)
register report "PCI Bus error". 
If someone know any clue of the reason, please let me know. 
Thanks

---------<from here>------------
# insmod via-rhine debug=7
Using /lib/modules/2.4.17/kernel/drivers/net/via-rhine.o
via-rhine.c:v1.10-LK1.1.12  03/11/2001  Written by Donald Becker
  http://www.scyld.com/network/via-rhine.html
via-rhine: reset finished after 5 microseconds.
eth0: VIA VT6102 Rhine-II at 0xea002000, 00:40:63:c3:98:09, IRQ 11.
eth0: MII PHY found at address 1, status 0x786d advertising 05e1 Link 45e1.
# ifconfig eth0 129.254.180.119 up
eth0: reset finished after 5 microseconds.
eth0: Setting full-duplex based on MII #1 link partner capability of 45e1.
# eth0: Something Wicked happened! 0040.                       <-----------
ERROR, net doesn't work. 
---------<end here>------------

-
HeeChul Yun,          
Embedded S/W Team at ETRI
phone: [phone]

[Ronald G. Minnich]

On Wed, 26 Mar 2003 [e-mail] wrote:
> When I tried to enable vt6102 ethernet, i got following error.  After
> tracking down the code, I found that it happen because ISR0 (0xc)
> register report "PCI Bus error".

Was ISR0 set to the value beforehand? Is it possible that the driver 
should be doing more to reset the hardware than it does?

ron