Hi, All, The output of my board is attached below. The MRC.bin is extracted from panther, which I assume matches my board. But the meminit fails. Do all the haswell use the same MRC, or how can I decide which mrc.bin is the one I should extract?
Thanks.
Zheng
coreboot-4.6-894-ga26344d-dirty Wed Jan 24 05:38:45 UTC 2018 romstage starting... Disabling Watchdog reboot... done. SMBus controller enabled. Setting up static northbridge registers... done. Initializing Graphics... Back from haswell_early_initialization() CPU id(40651) ucode:0000001c Intel(R) Core(TM) i7-4600U CPU @ 2.10GHz AES supported, TXT supported, VT supported PCH type: LP Premium, device id: 9c43, rev id 4 Starting UEFI PEI System Agent ___ CBFS: 'Master Header Locator' located CBFS at [300100:3fffc0) CBFS: Locating 'mrc.cache' CBFS: Found @ offset fec0 size 10000 find_current_mrc_cache_local: No valid MRC cache found. CBFS: 'Master Header Locator' located CBFS at [300100:3fffc0) CBFS: Locating 'mrc.bin' CBFS: Found @ offset 9fec0 size 2eb04 System Agent: Starting up... System Agent: Initializing PCH install_ppi: overwrite GUID {ed097352-9041-445a-80b6-b29d509e8845} install_ppi: overwrite GUID {908c7f8b-5c48-47fb-8357-f5fd4e235276} System Agent: Initializing PCH (SMBUS) System Agent: Initializing PCH (USB) System Agent: Initializing PCH (SA Init) System Agent: Initializing PCH (Me UMA) System Agent: Initializing Memory System Agent: Done. Sanity checking heap. sdram_initialize,153: rv=0 here. sdram_initialize,186 sdram_initialize,189 ME: FW Partition Table : OK ME: Bringup Loader Failure : NO ME: Firmware Init Complete : NO ME: Manufacturing Mode : YES ME: Boot Options Present : NO ME: Update In Progress : NO ME: Current Working State : Normal ME: Current Operation State : Bring up ME: Current Operation Mode : Security Override via Jumper ME: Error Code : No Error ME: Progress Phase : BUP Phase ME: Power Management Event : Pseudo-global reset ME: Progress Phase State : 0x66 RAM INIT FAILURE!
-
Zheng Bao