I finally made the jump and compiled a freebios2 image for the Epia M
but it's not booting at all. I used the default Config.lb, except that
I changed the serial speed to 115200 and the payload to etherboot.
Now, I get nothing on the serial port and the system locks up hard.
Booting with the stock BIOS doesn't even bring it to life unless I clear
CMOS, remove the power and let it sit for a little bit. Anybody know
what I can try besides banging my head against the wall? Thanks.
Show replies by date
I just don't recall where we are on epia-m and V2. I am doing the pentium
M port this month and until that's done epia will have to wait, unless
somebody else steps up to do it.