Look through the vt823x code in chipset_enable.c and also the epia-cn code in board_enable.c. Check the values of the registers modified by those functions, and if your board's registers don't match those values, call the appropriate function at the end of the board_enable for your board. Sorry I can't be more specific, I only have a few minutes to check email.
-Corey
Hello Peter,
Is there something that i can look into? or any pointers?
Please help!
Rgds,
VinodOn Tue, Mar 31, 2009 at 10:31 AM, vinuxesgmail <vinuxes@gmail.com> wrote:
Peter,
I am stuck with the same error even after applying the new patch. Here's the command output:
{-------------------
stress:/tmp # ./flashrom -m "portwell:ppap-2020vl" -E Calibrating delay loop... OK.Found board "Portwell PPAP-2020VL", enabling flash write... OK.
No coreboot table found.
Found chipset "VIA VT8237", enabling flash write... OK.stress:/tmp # ./flashrom -m "portwell:ppap-2020vl" -w backup.bin
Found chip "SST SST49LF004A/B" (512 KB) at physical address 0xfff80000.
Erasing flash chip... ERASE FAILED!
FAILED!
ERROR at 0x00000000: Expected=0xff, Read=0x49
-------------------Found board "Portwell PPAP-2020VL", enabling flash write... OK.
Calibrating delay loop... OK.
No coreboot table found.
Found chipset "VIA VT8237", enabling flash write... OK.
Found chip "SST SST49LF004A/B" (512 KB) at physical address 0xfff80000.Flash image seems to be a legacy BIOS. Disabling checks.Please guide me further.
ERASE FAILED!
-------------------}
Regards,
Vinod
Peter Stuge wrote:
Gah! Sorry. Here it is.
//Peter
--
coreboot mailing list: coreboot@coreboot.org
http://www.coreboot.org/mailman/listinfo/coreboot