you can't fit X onto the DoC you can buy today.
Fasted boot I've seen is with the kernel in DoC, then mount /dev/hda1 as
/.
ron
Even an X like Qt embedded? My Zaurus only has 32Mb on it, and it boots
into X in about 4 seconds. While I don't expect _that_ speedy of a boot,
I would think I could achieve significantly less than 35(ish) seconds it
takes now. Also, did you factor in the IDE spinup boot delay of having an
IDE /. directory? If the DOC+IDE is faster, do you mean throughput wise
or time wise? I'm referring to an earlier message that you replied to Todd
Johnson and his boot times (message below). It seemed as if the 2 emails
conflict in what they're saying, so I just wanted to ask for a little clarification
(not doubting you, just a little unclear on the principle).
Essentially what I'm wondering is if a small footprint X could be booted
into via DOC and if it would be faster than DOC+IDE (considering the IDE
spinup delay).
Your thoughts?
Ronald G Minnich wrote:
On Sun, 29 Sep 2002, Christopher Bergeron wrote:
Can anyone give me advice on what will acheive the fastest boot time?
My options are the LinuxBIOS coupled with a DOC root or with root
configured on hda1 (IDE). I boot into X and I'll need standard
modules loaded. I'd like to fit the entire install on a DOC but only
IF I'll get a faster load/boot.
you can't fit X onto the DoC you can buy today.
Fasted boot I've seen is with the kernel in DoC, then mount /dev/hda1 as
/.
ron
On Fri, 4 Oct 2002, Todd E. Johnson wrote:
BTW, it seems that there is no booting action (Based on the Serial
> output) until the HDD spins up. Is this a result of me keeping my root
> file system on the HDD?
you can't do anything until the HDD spins up, and yes it's because you've
god file system on the HDD. There's not much to be done for this.
ron