in http://wiki.solid-run.com/doku.php?id=products:ibx:documents , there is SolidPC Schematics :

page 1 : you can read: 

""Notice that the programmer must drive 1.8v signals; otherwise
the main processor might get damaged.""


2016-12-14 15:05 GMT+01:00 Peter Stuge <peter@stuge.se>:
sebastien basset wrote:
> For flashing board solidpc,
> 1/  plug power supply (without pressing the power button)
> 2/ connect dediprog on j8 connector( with good cable)
> 3/ ./flashrom -p dediprog:voltage=1.8V -w solidrun.rom

Why 1.8V? Is there a schematic available for this board?


//Peter

--
coreboot mailing list: coreboot@coreboot.org
https://www.coreboot.org/mailman/listinfo/coreboot



--
Sébastien Basset