Re: [coreboot] Where does printk() message go in coreboot source code

[Peter Stuge]

fengwei zhang wrote:
> I am new to coreboot.

Welcome.
> Do you guys know where printk() statement go in coreboot source code?
>
> e.g. printk(BIOS_DEBUG, "%s\n", msg);

Typically to the first serial port on the board. Some chipsets/boards
can also use EHCI Debug Port. And finally there is support for
sending console output over UDP using a RTL8029 NIC.

If coreboot is configured to initialize a VGA option ROM (rare and
not recommended, normally handled by SeaBIOS) then any printk()
following that initi (usually none) would also be visible on the
monitor.

//Peter