Ok<br>
for that<br>
 &nbsp;&nbsp; #VGA Console<br>
 &nbsp; &nbsp;option CONFIG_CONSOLE_VGA=1<br>
 &nbsp; &nbsp;option CONFIG_PCI_ROM_RUN=1<br>
<br>
In the config <a href="http://Option.lb">Option.lb</a> i had to<br>
define CONFIG_CONSOLE_VGA<br>
define CONFIG_PCI_ROM_RUN<br>
<br>
CONFIG_CONSOLE_VGA=1<br>
CONFIG_PCI_ROM_RUN=1<br>
<br>
Sorry for being dum lol<br>
<br>
I have a flash chip that goes from 00000h to 3FFFFh.&nbsp; I am only
using fallback and filo.&nbsp; Starting at address 00000h for 48KB is
my VGA bios.&nbsp; It is all FFh until address 20000h.&nbsp; At address
20000h is the start of my filo for 58KB then all FFh to address 30000h
where my linuxbios is ?&nbsp; I do have instruction codes at 3FFF0h to
3FFFFh.&nbsp; When I boot no output serial or vga.&nbsp; <br>
<br>
However, when i compile without VGA and use normal and fallback i get
serial output.&nbsp; Can anyone explain those above addresses so I can
understand them better.<br>
<br>
Thanks,<br>
Tyler Pohl<br>