Hi Urbez,

> 4. Add the follow code to the end of the function main() in auto.c: if
> not, your normal IDE cannot use DMA and via-rhine, usb's, etc, not
> works.
>
> //This enable the access of PCI devices to the PCI bus master?
> pci_write_config8(cn700->d0f7, 0x57, 0x20);//was 0x01

I think this is connected to some last DRAM address stuff. DMA may not work if
this is incorrect. Consult some similar datasheet
jjj.ivn.pbz.gj!ra!qbjaybnqf!qngnfurrgf!puvcfrgf!QF_PA400_118.mvc
It may be the last bank ending address??? Perhaps this must be copied from
function 3 maybe?

Exactly

>
> 5. If you will that the FILO not confuses scanning PCI, you must add, to
> the end of main() in auto.c:
>
> pci_write_config8(cn700->d1f0,0x19,0x1,CF8);//enable PCI-BRIGDE
> SECONDARY BUS
> pci_write_config8(cn700->d1f0,0x1a,0x1,CF8);

Perhaps is something translating configuration cycles?

Rudolf

Nope, secondary and subordinate bus number. But what's up with the CF8 at the end of these commands?

-Corey