Hi Michal,

Thank you very much for your reply. 

You are right. I have soldered down memory. No dimm slot. 

In what routine should I  configure RAM ?  Where can I see a sample code ?

From the RAM vendor I got the following table:

Part Number	Byte Number	Byte Description	Byte Value
MT4KTF25664HZ-1G9P1	0	DDR3-CRC RANGE; EEPROM BYTES; BYTES USED	92
MT4KTF25664HZ-1G9P1	1	DDR3-SPD REVISON	13
MT4KTF25664HZ-1G9P1	2	DDR3-DRAM DEVICE TYPE	0B
MT4KTF25664HZ-1G9P1	3	DDR3-MODULE TYPE (FORM FACTOR)	3

....

Is it possible to use FSP but not for RAM setup ?  How ?

FSP has many features which I want to use. I do not want to write all by myself.

Great that You have found the SPD. AFAIK FSP1.0 has only one entry available (except TempRamInit), i.e. FspInit which initializes memory and silicon. It is inseparable comparing to FSP1.1 or FSP2.0, so everything has to be set right away from the start. FSP will always be used for RAM setup for BayTrail, unless You have a MRC binary. Of course there are some boards that do not need any blob for memory initialization, but this is out of scope of this topic.

Most configuration settings for FSP is defined in mainboard's devicetree.cb file. What You would have to do in the devicetree is to set EnableMemoryDown option and all other memory parameters DIMM* and DRAM* (taken from SPD) as listed here (only example of minnowmax):
https://github.com/coreboot/coreboot/blob/master/src/mainboard/intel/minnowmax/devicetree.cb#L36

You don't need to worry much about writing code, since everything is almost in place. Have a look at:
src/soc/intel/fsp_baytrail/fsp/chipset_fsp_util.c and src/drivers/intel/fsp1_0/fsp_util.c

The settings are automatically filled and FspInitApi is called with the parameters You set in devicetree.
What You only need is to create a mainboard directory for Your platform and implement few necessary callbacks. First and foremost, coreboot is a framework :)

Best regards,

Zvika 

-- 
Michał Żygowski
Firmware Engineer
http://3mdeb.com | @3mdeb_com