Finally my linuxbios bring up the target board.

capture5.txt is booting log.

But most of device on the target board are not work.

Such as BCM5704 under PCI-X bridge.

If I try to load "tg3" module into the kernel, I got error message like this,

[root@linuxbios ~]# modprobe tg3
PCI: No IRQ known for interrupt pin A of device 0000:03:04.0. Please try using pci=biosirq.
PCI: No IRQ known for interrupt pin B of device 0000:03:04.1. Please try using pci=biosirq.

How to assign an IRQ for each device ??

2006/5/12, Stefan Reinauer <stepan@coresystems.de>:

* Vincente Tsou <vincentetsou@nexcom.com.tw> [060512 06:22]:
> Dear Lu and Stefan,
>
> Thank you very much for your reply.
>
> But I can't find the inherent_ht.c in my LinuxBios source tree.

Yinghai is talking about src/northbridge/amd/amdk8/incoherent_ht.c

You need to try commenting out the lines I sent in the last mail from
src/northbridge/amd/amdk8/resourcemap.c

Stefan

--
coresystems GmbH • Brahmsstr. 16 • D-79104 Freiburg i. Br.
Tel.: +49 761 7668825 • Fax: +49 761 7664613
Email: info@coresystems.de • http://www.coresystems.de/