On 08.08.2019 08:28, Persmule wrote:
Hi Michal,



On Wednesday, August 7, 2019 10:06 AM, Michal Zygowski <michal.zygowski@3mdeb.com> wrote:

Here is an example:https://github.com/coreboot/coreboot/blob/master/src/mainboard/lenovo/x220/vboot-rwa.fmd

Vboot is responsible for firmware verification (checks firmware signature blocks). The TPM measurements are only an extension to Vboot logic adopted in coreboot. In order to have verified boot, at least one RW partition must exists.

Is it possible to omit RW sections completely, letting vboot always boot into "system recovery" (in the RO section) which is actually used for normal boot?
(I believe that stages and payloads in the RO section will be measured too when booting into "system recovery". Please correct me if I am wrong.)
Yes, if you are interested entirely in measured boot mode only, the RO section is sufficient.

for Measured boot, only single CBFS is fine. to support verified and measured boot, one RW partition is sufficient. The example linked above has the minimal fmap layout for verified and measured boot for Lenovo x220. SMMSTORE is optional as well as RW_VPD and RO_VPD (depends on use case). SI_GBE region is mandatory for vPRO platforms to support Gigabit Ethernet, SI_ME and SI_DESC are Intel ME and Flash descriptor regions, also mandatory.

Besides, at least how many bytes should be retained for the GBB section?
The GBB is much greater since ChromeOS recovery bitmaps resides there. For non-ChromeOS devices (like many Lenovo laptops implement in coreboot) I saw min 120KiB (0x1e000). Should be sufficient. Example fmap description of flash with RO section:
https://github.com/coreboot/coreboot/blob/master/src/mainboard/ocp/wedge100s/vboot-ro.fmd
(probably you would like to adjust some offsets and sizes)


_______________________________________________
coreboot mailing list -- coreboot@coreboot.org
To unsubscribe send an email to coreboot-leave@coreboot.org
-- 
Michał Żygowski
Firmware Engineer
http://3mdeb.com | @3mdeb_com