Hi. I'm with "Check your configuration (optional step):".
I did
$ make savedefconfig
$ cat defconfig
The instructions say:
"There should only be two lines (or 3 if you’re using the system toolchain):
CONFIG_PAYLOAD_ELF=y
CONFIG_PAYLOAD_FILE="payloads/coreinfo/build/coreinfo.elf""
I wasn't using the system toolchain. It's clear I installed SeaBIOS instead of coreinfo.
I got the following response:
CONFIG_CBFS_SIZE=0x00040000
CONFIG_CONSOLE_CBMEM_BUFFER_SIZE=0x20000
CONFIG_UART_PCI_ADDR=0x0
CONFIG_SUBSYSTEM_VENDOR_ID=0x0000
CONFIG_SUBSYSTEM_DEVICE_ID=0x0000
CONFIG_CONSOLE_QEMU_DEBUGCON_PORT=0x402
CONFIG_POST_IO_PORT=0x80
CONFIG_SEABIOS_DEBUG_LEVEL=-1
I've already asked the corresponding question regarding coreinfo but is it the same with SeaBIOS:
Is it a problem that there are 8 lines instead of only two lines? Do I need to fix anything or could I just continue?
Regards,
Bernd
Step 4 simply builds coreinfo by itself, the original step 5 simply adds the output of step 4 to the coreboot image. There shouldn't be an issue if you just continue on with the other steps.
From: bernd1-1@web.deSent: November 8, 2021 12:49 a.m.To: nic.c3.14@gmail.comCc: coreboot@coreboot.orgSubject: AW:[coreboot] Re: Installing coreboot with SeaBIOS
Hi. As I'm on
Step 5 - Configure the build > Check your configuration (optional step):
right now and already made the previous steps, I can't skip step 4 anymore. I already made step 4.
Do I need to delete the current installation and start over or is step 4 no problem and I could just go on with step 5? What should I do?
Regards,
Bernd