Nick, would you please help to correct same malefor settings during your CL?
4 comments:
File src/mainboard/google/volteer/variants/malefor/gpio.c:
/* E10 : SPI1_CS# ==> USB_C0_AUXP_DC */
PAD_CFG_GPO(GPP_E10, 0, DEEP),
This pin should removed since MB side need AUX function which should keep same as baseboard settings.
/* E13 : SPI1_MOSI_IO0 ==> USB_C0_AUXN_DC */
PAD_CFG_GPO(GPP_E13, 0, DEEP),
This pin should removed since MB side need AUX function which should keep same as baseboard settings.
/* H20 : IMGCLKOUT1 ==> EN_MIPI_RCAM_PWR */
PAD_CFG_GPO(GPP_H20, 1, PLTRST),
malefor doesn't use MIPI camera, so this pin should same as baseboard with NC settings.
/* F11 : THC1_SPI2_CLK ==> EN_PP3300_WWAN */
PAD_CFG_GPO(GPP_F11, 1, DEEP),
/* F12 : GSXDOUT ==> WWAN_RST_ODL
To meet timing constrains - drive reset low.
Deasserted in ramstage. */
PAD_CFG_GPO(GPP_F12, 0, DEEP),
malefor doesn't need these WWAN related GPIO settings, should keep NC.
To view, visit change 41797. To unsubscribe, or for help writing mail filters, visit settings.