Patch Set 18:
(5 comments)
I'm sorry for the waiting. I urgently needed to finish the project at work.
No worries, there's no time pressure with this port. Any input is appreciated :D
as he ported asrock/h110m
This work isn't completed yet. Now I'm working on gpio, and after that I need to solve problems with superio.
Good luck :)
and probably knows Skylake stuff better than I do
I'm not sure about that :)
I don't have any Skylake hardware to look at :S
2 comments:
File src/mainboard/asus/h110m-e_m2/devicetree.cb:
device pci 14.2 on # Thermal Subsystem
subsystemid 0x1849 0xa131
end
Are you sure about that? This device is always enabled on boards with AMI UEFI.
I checked the lspci with vendor BIOS for that board and it is reported as disabled. (does not appear)
device pci 16.0 on # Management Engine Interface 1
subsystemid 0x1849 0xa131
end
Probably me_cleaner was used to disable this device. However, we need to be very careful with ME: […]
Could be me_cleaner, yes.
While doing the porting, I would recommend using a working ME firmware. Weird issues may happen with a me_cleaned firmware, and troubleshooting them is nearly impossible.
To view, visit change 34603. To unsubscribe, or for help writing mail filters, visit settings.