hatch: Fix FPMCU pwr/rst gpio handling

1. No gpio control in bootblock
2. Disable power and assert reset in ramstage gpio
3. Power on and then deassert reset at the end of ramstage gpio
4. Disable power and assert reset when entering S5

On "reboot", the amount of time the power is disabled for is
equivalent to the amount of time between triggering #4 and wrapping
around to #3, which is about 400ms on Kohaku.

Since #2 forces power off for FPMCU, S3 resume will still
not work properly.

The control signals have been validated on a Kohaku in
the following scenarios:
1. Cold startup
2. Issuing a "reboot" command
3. Issuing a "halt -p" and powering back on within 10 seconds
4. Issuing a "halt -p" and powering back on after 10 seconds
5. Entering and leaving S3 (does not work properly)
6. Entering and leaving S0iX

BRANCH=hatch
BUG=b/142751685
TEST=Verify all signals as mentioned above
TEST=reboot
     flash_fp_mcu /opt/google/biod/fw/dartmonkey_v2.0.2417-af88cc91a.bin
TEST=halt -p
     # power back on within 10 seconds
     flash_fp_mcu /opt/google/biod/fw/dartmonkey_v2.0.2417-af88cc91a.bin
TEST=halt -p
     # power back on after 10 seconds
     flash_fp_mcu /opt/google/biod/fw/dartmonkey_v2.0.2417-af88cc91a.bin

Change-Id: I2e3ff42715611d519677a4256bdd172ec98687f9
Signed-off-by: Craig Hesling <hesling@chromium.org>
---
M src/mainboard/google/hatch/ramstage.c
M src/mainboard/google/hatch/variants/baseboard/gpio.c
M src/mainboard/google/hatch/variants/baseboard/include/baseboard/variants.h
M src/mainboard/google/hatch/variants/helios/Makefile.inc
M src/mainboard/google/hatch/variants/helios/gpio.c
A src/mainboard/google/hatch/variants/helios/ramstage.c
M src/mainboard/google/hatch/variants/kindred/gpio.c
M src/mainboard/google/hatch/variants/kohaku/Makefile.inc
M src/mainboard/google/hatch/variants/kohaku/gpio.c
A src/mainboard/google/hatch/variants/kohaku/ramstage.c
10 files changed, 127 insertions(+), 22 deletions(-)