7 comments:

File util/superiotool/ite.c:
- Patch Set #1, Line 856:
```
0x30,0x60,0x61,0x70,0xf0,0xf1,EOT},
			{0x00,0x03,0xf8,0x04,0x00,0x50,EOT}},
```
  the chip only has one serial port (don't know if the same die is used in a bigger package that has a […]
  COM2 does not exist.
- Patch Set #1, Line 865: 0x08
  WARNING: Table 8-4 incorrectly lists this value as 0x48! The register description marks the upper bits as RSVD and says they should be zero.
- Patch Set #1, Line 874: ,
  It is not in my datasheet.
  Oh, it actually is there? It only appears on the table, not on the register description...
  I'll put it in just in case.
- Patch Set #1, Line 877: 0x03
  0x01
  Done
- Patch Set #1, Line 878: MISC
  0x20
  Ah, I know why I put MISC: one of the bits selected by means of strapping, so I was not sure if it mattered.
- Patch Set #1, Line 880: 0x00
  0x40
  There's differences between the table values and the register description value...
  Table says 0x40, but register description says 0x00
  In any case, looks like this bit is meaningless because GPIO46 is not supported.
- Patch Set #1, Line 881: 0x40
  0x00
  There's differences between the table values and the register description value...
  Table says 0x00, but register description says 0x40
  In any case, looks like this bit is meaningless because GPIO46 is not supported.

To view, visit change 30224. To unsubscribe, or for help writing mail filters, visit settings.