View Change

2 comments:

• Commit Message:

  • Patch Set #3, Line 9: Volteer world-facing camera has a privacy LED and it is supposed

    Silly question: for new designs, why not just wire the LED to the same GPIO that controls the camera […]

    Actually, this is a long story. Wiring the LED to the power works with most cases. But during the boot, the LED will lit while the camera is being probed. This can give the users a wrong impression that camera is being used. To fix this issue, both HW/SW should be changed and my understanding is this is for the HW side change.

  • Patch Set #3, Line 13: power up

    Not sure if it would look too good with the "and down" part that goes after it

    Done

To view, visit change 42985. To unsubscribe, or for help writing mail filters, visit settings.