Keith Short has uploaded this change for review.
src/soc/intel/common: Clear GPIO driver ownership when not requested
The default state of the HOSTSW_OWN register in the PCH is zero, which
configures GPIO pins for ACPI ownership. The board variabt GPIO tables
can request specific pins to be configured for GPIO driver ownership.
This change sets the HOSTSW_OWN ownership bit when requested and
explicitly clears the ownership bit if not requested.
BUG=b:120884290
BRANCH=none
TEST=Build coreboot on sarien. Verified UEFI to coreboot transition
boots successfully.
Change-Id: Ia82539dbbbc7cf5dfb9223902d563cafec1a73e5
Signed-off-by: Keith Short <keithshort@chromium.org>
---
M src/soc/intel/common/block/gpio/gpio.c
1 file changed, 17 insertions(+), 10 deletions(-)
git pull ssh://review.coreboot.org:29418/coreboot refs/changes/09/31209/1
diff --git a/src/soc/intel/common/block/gpio/gpio.c b/src/soc/intel/common/block/gpio/gpio.c
index 294218c..51e7b47 100644
--- a/src/soc/intel/common/block/gpio/gpio.c
+++ b/src/soc/intel/common/block/gpio/gpio.c
@@ -131,23 +131,30 @@
static void gpio_configure_owner(const struct pad_config *cfg,
const struct pad_community *comm)
{
- uint16_t hostsw_reg;
+ uint32_t hostsw_own;
+ uint16_t hostsw_own_offset;
int pin;
pin = relative_pad_in_comm(comm, cfg->pad);
- /* The 4th bit in pad_config 1 (RO) is used to indicate if the pad
- * needs GPIO driver ownership.
- */
- if (!(cfg->pad_config[1] & PAD_CFG1_GPIO_DRIVER))
- return;
-
/* Based on the gpio pin number configure the corresponding bit in
* HOSTSW_OWN register. Value of 0x1 indicates GPIO Driver onwership.
*/
- hostsw_reg = comm->host_own_reg_0;
- hostsw_reg += gpio_group_index_scaled(comm, pin, sizeof(uint32_t));
- pcr_or32(comm->port, hostsw_reg, gpio_bitmask_within_group(comm, pin));
+ hostsw_own_offset = comm->host_own_reg_0;
+ hostsw_own_offset += gpio_group_index_scaled(comm, pin, sizeof(uint32_t));
+
+ hostsw_own = pcr_read32(comm->port, hostsw_own_offset);
+
+ /* The 4th bit in pad_config 1 (RO) is used to indicate if the pad
+ * needs GPIO driver ownership. Set the bit if GPIO driver ownership
+ * requested, otherwise clear the bit.
+ */
+ if (cfg->pad_config[1] & PAD_CFG1_GPIO_DRIVER)
+ hostsw_own |= gpio_bitmask_within_group(comm, pin);
+ else
+ hostsw_own &= ~gpio_bitmask_within_group(comm, pin);
+
+ pcr_write32(comm->port, hostsw_own_offset, hostsw_own);
}
static void gpi_enable_smi(const struct pad_config *cfg,
To view, visit change 31209. To unsubscribe, or for help writing mail filters, visit settings.