Matt DeVillier has uploaded this change for review.
mb/google/cyan: Switch eMMC and SD from ACPI to PCI mode
Braswell boards don't work well with the eMMC and SD controller
in ACPI in payloads other than depthcharge - SeaBIOS requires
an onerous workaround, and Tianocore can't see the devices
at all. To make the common use-case work better, switch
from ACPI mode to PCI mode.
Test: build/boot cyan variants with SeaBIOS and Tianocore
payloads, verify eMMC and SD card visible and bootable.
Change-Id: I71947603e22a37fe2c8ef4eaac8a3aa0d0ed1cec
Signed-off-by: Matt DeVillier <matt.devillier@gmail.com>
---
M src/mainboard/google/cyan/devicetree.cb
1 file changed, 5 insertions(+), 5 deletions(-)
git pull ssh://review.coreboot.org:29418/coreboot refs/changes/02/40002/1
diff --git a/src/mainboard/google/cyan/devicetree.cb b/src/mainboard/google/cyan/devicetree.cb
index d5f7a3f..5df1a5a 100644
--- a/src/mainboard/google/cyan/devicetree.cb
+++ b/src/mainboard/google/cyan/devicetree.cb
@@ -19,7 +19,7 @@
# Set the parameters for SiliconInit
############################################################
- register "PcdSdcardMode" = "PCH_ACPI_MODE"
+ register "PcdSdcardMode" = "PCH_PCI_MODE"
register "PcdEnableHsuart0" = "0"
register "PcdEnableHsuart1" = "1"
register "PcdEnableAzalia" = "1"
@@ -36,7 +36,7 @@
register "PcdEnableI2C6" = "0"
register "PunitPwrConfigDisable" = "0" # Enable SVID
register "ChvSvidConfig" = "SVID_PMIC_CONFIG"
- register "PcdEmmcMode" = "PCH_ACPI_MODE"
+ register "PcdEmmcMode" = "PCH_PCI_MODE"
register "PcdUsb3ClkSsc" = "1"
register "PcdDispClkSsc" = "1"
register "PcdSataClkSsc" = "1"
@@ -84,10 +84,10 @@
# LPE audio codec settings
register "lpe_codec_clk_src" = "LPE_CLK_SRC_XTAL" # 19.2MHz clock
- # Enable devices in ACPI mode
+ # Enable LPSS and LPE devices in ACPI mode
register "lpss_acpi_mode" = "1"
- register "emmc_acpi_mode" = "1"
- register "sd_acpi_mode" = "1"
+ register "emmc_acpi_mode" = "0"
+ register "sd_acpi_mode" = "0"
register "lpe_acpi_mode" = "1"
# Disable SLP_X stretching after SUS power well fail.
To view, visit change 40002. To unsubscribe, or for help writing mail filters, visit settings.