Hi, After this patch applied: http://patchwork.coreboot.org/patch/2452/ And finnaly added " -p internal:boardenable=force" to the command line. It says VERIFIED, I think everything went well using the MSI 848P Neo-V motherboard. server-pc:/home/melroy# flashrom -p internal:boardenable=force -w A6788IMS.610 flashrom v0.9.3-r1247 on Linux 2.6.26-2-686 (i686), built with libpci 3.0.0, GCC 4.3.2, little endian flashrom is free software, get the source code at http://www.flashrom.org Calibrating delay loop... OK. No coreboot table found. Found chipset "Intel ICH5/ICH5R", enabling flash write... OK. This chipset supports the following protocols: FWH. NOTE: Running an untested board enable procedure. Please report success/failure to flashrom@flashrom.org with your board name and SUCCESS or FAILURE in the subject. Disabling flash write protection for board "MSI MS-6788-040 (848P NeoV)"... OK. Found chip "Winbond W39V040FA" (512 KB, FWH) at physical address 0xfff80000. === This flash part has status UNTESTED for operations: WRITE The test status of this chip may have been updated in the latest development version of flashrom. If you are running the latest development version, please email a report to flashrom@flashrom.org if any of the above operations work correctly for you with this flash part. Please include the flashrom output with the additional -V option for all operations you tested (-V, -Vr, -Vw, -VE), and mention which mainboard or programmer you tested. Please mention your board in the subject line. Thanks for your help! Flash image seems to be a legacy BIOS. Disabling checks. Erasing and writing flash chip... Done. Verifying flash... VERIFIED. The (latest) BIOS can be found at the MSI website. -- Kind regards, Melroy van den Berg