Hi, I used flashrom to flash my new OEM BIOS. My board is a GIGABYTE GA-MA78G-DS3H (Revision 1). Thanks for this really nice tool. :) Flashrom told me that I should confirm on this list if I successfully erased the BIOS: "This flash part has status UNTESTED for operations: ERASE Please email a report to flashrom@flashrom.org if any of the above operations work correctly for you with this flash part. Please include the flashrom output with the additional -V option for all operations you tested (-V, -rV, -wV, -EV), and mention which mainboard you tested. Thanks for your help!" That is what I'm doing here, the log file is attached. I erased my flash, then read out and it was deleted. Then I flashed a new BIOS and rebooted my system. Now I use the new BIOS, F8 instead of F6. There are two things I noticed: - Flashrom tells: "Disabling flash write protection for board "GIGABYTE GA-MA78GM-S2H"... Serial flash segment 0xfffe0000-0xffffffff enabled" This is not my mainboard, I have a DS3H, but it works anyway. - When writing to the chip, there is a break where it is not clear what flashrom does: "[...] Writing flash chip... Erasing flash before programming... Erasing flash chip... Looking at blockwise erase function 0... trying... SUCCESS. done. [HERE IS A CA. 3 MINUTES BREAK] COMPLETE. Verifying flash... VERIFIED." Maybe you should add a "still in progress" or similar. "Done" looks like it has completed the whole process. Also the CPU uses 100% while flashing/erasing/verifying, I don't know it this is normal. If you need more information just ask me, but write to my private email address since I don't subscribe to the mailing list. Thanks, Yul Rottmann