Hello Paul Menzel, build bot (Jenkins), I'd like you to reexamine a change. Please visit https://review.coreboot.org/23050 to look at the new patch set (#2). Change subject: buspirate_spi: Add support for variable serial speeds ...................................................................... buspirate_spi: Add support for variable serial speeds This patch introduces the ability to set the baud rate for communication between the host device and the Bus Pirate via the added 'serialspeed' programmer parameter. This is done in two parts. Firstly, the requested serial speed is looked up in a table to determine the appropriate clock divisor and the divisor is sent to the bus pirate. Then, the system's baud rate for the selected serial port is set using serial.c's 'serialport_config'. This function's prototype had to be added to programmer.h. In testing, using the 2M baud rate was able to significantly decrease flash times (down from 20+ minutes to less than 2 minutes for an 8MB flash). Change-Id: I3706f17a94fdf056063f2ad4a5f0a219665cdcbf Signed-off-by: Shawn Anastasio <shawnanastasio@yahoo.com> --- M buspirate_spi.c M programmer.h 2 files changed, 89 insertions(+), 7 deletions(-) git pull ssh://review.coreboot.org:29418/flashrom refs/changes/50/23050/2 -- To view, visit https://review.coreboot.org/23050 To unsubscribe, or for help writing mail filters, visit https://review.coreboot.org/settings Gerrit-Project: flashrom Gerrit-Branch: staging Gerrit-MessageType: newpatchset Gerrit-Change-Id: I3706f17a94fdf056063f2ad4a5f0a219665cdcbf Gerrit-Change-Number: 23050 Gerrit-PatchSet: 2 Gerrit-Owner: Shawn Anastasio <shawnanastasio@yahoo.com> Gerrit-Reviewer: Paul Menzel <paulepanter@users.sourceforge.net> Gerrit-Reviewer: build bot (Jenkins) <no-reply@coreboot.org>