<div dir="ltr"><div><div><div><div><div><div><div><div><div><div><div>Hi,<br></div>I am a newbie, so please be patient.<br></div>I want flash my bios because I have a suspect of an internal rootkit. <br></div>I have found the following link<br><a href="https://tomvanveen.eu/flashing-bios-chip-raspberry-pi/">https://tomvanveen.eu/flashing-bios-chip-raspberry-pi/</a><br></div>where it looks pretty easy to flash the chip by raspberry.<br></div>I have a pomona 5250 clip and my problem is connect the clip to the exact pins on the W25X32 chip (from raspberry).<br></div>I have downloaded the datasheet  here:<br><a href="http://pdf1.alldatasheet.com/datasheet-pdf/view/207471/WINBOND/W25X32/+Q07W8_VThMwPPh+bYweww+/datasheet.pdf">http://pdf1.alldatasheet.com/datasheet-pdf/view/207471/WINBOND/W25X32/+Q07W8_VThMwPPh+bYweww+/datasheet.pdf</a><br></div>In the above link (<a href="https://tomvanveen.eu/flashing-bios-chip-raspberry-pi/">https://tomvanveen.eu/flashing-bios-chip-raspberry-pi/</a>) there is the schema to connect the wires.. but what I don't understand is if the raspberry pin 17 must be connected to 3 pins on the chip.. On the schema there is written:<br><br>(raspberry) 17 ---> (w25x32) VCC 3.3V and /HOLD and /WP<br><br></div>Then do I have to connect the pin 17 to vcc and /hold and /wp ????<br></div>I ask this because seeing  the photos it looks connected to just one pin.<br></div>Thank you very much.<br></div>LWS<br><br><div><div><br></div></div></div>